- 1. Bit-zee
- 2. Bit-zee (long version)
- 3. Bit-zee Bot Introduction
- 4. Bit-zee planning and propulsion
- 5. Bit-zee's bits
- 6. Bit-zee's chassis/frame
- 7. Bit-zee's wheel mounts and fenders
- 8. Bit-zee's component mounting holes
- 9. Bit-zee's batteries
- 10. Improving the battery wires
- 11. Connecting Bit-zee's power wires and on-off switch
- 12. Bit-zee's motors
- 13. Why does Bit-zee need a motor controller?
- 14. Bit-zee's motor controller
- 15. Attaching and wiring Bit-zee's motor controller
- 16. Attaching Bit-zee's Arduino
- 17. How to hotwire a digital camera
- 18. Attaching Bit-zee's digital camera
- 19. Bit zee's 5 Volt power distribution board
- 20. Hacking and attaching a digital recorder/player to Bit-zee
- 21. Making a power connector for the Arduino
- 22. Attaching Bit-zee's prototype board
- 23. Connecting the motor controller to the Arduino
- 24. Connecting Bit-zee's camera to the Arduino
- 25. Bit-zee's bumper switches
- 26. Bit-zee's eyes
- 27. Bit-zee's IR sensor
- 28. Bit-zee's shell
- 29. Camera wiring update
- 30. Load the Code for It-zee and Bit-zee
17. How to hotwire a digital camera This video shows you how to "hotwire" a digital camera. This video outlines the first step in making our digital camera work in the Bit-zee robot. The required voltage for the camera was determined by adding the1.5 volt AAA batteries (there are three of them) together to get 4.5 volts (because the batteries are wired in series). Since new batteries usually have a voltage that exceeds their marked rating the camera can easily run on the 5 volts that the center terminal of our L298 motor controller provides.
⇐ Use this menu to view and help create subtitles for this video in many different languages.
You'll probably want to hide YouTube's captions if using these subtitles.
Share a tip
Suggest a fix
Have something that's not a tip or feedback about this content?
This discussion area is not meant for answering homework questions.