- 1. Bit-zee
- 2. Bit-zee (long version)
- 3. Bit-zee Bot Introduction
- 4. Bit-zee planning and propulsion
- 5. Bit-zee's bits
- 6. Bit-zee's chassis/frame
- 7. Bit-zee's wheel mounts and fenders
- 8. Bit-zee's component mounting holes
- 9. Bit-zee's batteries
- 10. Improving the battery wires
- 11. Connecting Bit-zee's power wires and on-off switch
- 12. Bit-zee's motors
- 13. Why does Bit-zee need a motor controller?
- 14. Bit-zee's motor controller
- 15. Attaching and wiring Bit-zee's motor controller
- 16. Attaching Bit-zee's Arduino
- 17. How to hotwire a digital camera
- 18. Attaching Bit-zee's digital camera
- 19. Bit zee's 5 Volt power distribution board
- 20. Hacking and attaching a digital recorder/player to Bit-zee
- 21. Making a power connector for the Arduino
- 22. Attaching Bit-zee's prototype board
- 23. Connecting the motor controller to the Arduino
- 24. Connecting Bit-zee's camera to the Arduino
- 25. Bit-zee's bumper switches
- 26. Bit-zee's eyes
- 27. Bit-zee's IR sensor
- 28. Bit-zee's shell
- 29. Camera wiring update
- 30. Load the Code for It-zee and Bit-zee
14. Bit-zee's motor controller In this video we take you step by step through building the L298 Motor driver. This controller allows you to use your Arduino to control the hair dryer motors used to move the Bit-zee bot.
⇐ Use this menu to view and help create subtitles for this video in many different languages.
You'll probably want to hide YouTube's captions if using these subtitles.
Share a tip
Suggest a fix
Have something that's not a tip or feedback about this content?
This discussion area is not meant for answering homework questions.